Fiber media converter using note

Fiber media converter have a variety of different classification, but note that most of the actual use of class distinction according to different fiber optic connectors: SC connector media converter and FC / ST media converter .
Fiber media converter to connect the different devices must use different ports.

1, the fiber converter to 100BASE-TX equipment (switches, hubs) connection:
Verify that the length of twisted pair up to over 100 m;
RJ-45 port to connect one end of the twisted pair to fiber converter (Uplink port), the other end of the set (switches, hubs) 100BASE-TX RJ-45 port (port).

2, the fiber converter to 100BASE-TX device (NIC) connections:
Verify that the length of twisted pair up to over 100 m;
RJ-45 port to connect one end of the twisted pair to Fiber media converters (100BASE-TX port), the other end of the RJ-45 port, network card.

3, fiber converter to 100BASE-FX connection:
Verify that the fiber length does not exceed the range of equipment to provide distance;

SC / ST connector, one end of the fiber with fiber media converters SC / FC / ST connector on one end to connect the 100BASE-FX device.

Also need to add is that many users in the use of fiber media converters that: as long as the length of the fiber is in the single-mode fiber or multimode fiber can support a maximum distance can be used normally. In fact, this is a wrong perception, this understanding is correct only when connected devices are full-duplex device, when there are half-duplex device, the optical fiber transmission distance there are certain restrictions.